Supra Carbon Number Plate Garnishes and Backing Plate Fitting Instructions

 

Toyota Supra Carbon Number Plate Garnishes and Backing Plate.

 

Fitting Carbon Backing Plate:

The mounting holes are pre-drilled to suit JDM Supra’s so you simply un-bolt your number plate then bolt the backing plate on behind the number plate.

 

Fitting Carbon Garnishes:

Position the garnishes so they sit neatly to either side of your number plate or the carbon backing plate (this will depend on your number plate size). Once you have worked out where they will sit clean the bumper and the back of the garnishes with wax and grease remover to ensure good adhesion.

Then onto the back of the garnishes along the protruding ridges apply either Black Sikaflex 252 (use good quality masking tape to hold in place while it sets) or 3M VHB tape 4991 (heat with a hair dryer then press and hold firmly for 1min+) you attach the garnishes to the bumper.

Follow the adhesive instructions and once it has fully set check they are firmly attached.

 

Please note these fitting instructions are a guide only, we recommend professional installation and accept no liability regarding installation or use of this product.